[. . . ] Correct use · This dishwasher is only intended for washing household utensils suitable for machine washing. · Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. · Only use products (detergent, salt and rinse aid) suitable for dishwashers. · Avoid opening the door whilst the appliance is in operation, hot steam may escape. [. . . ] When using detergent tablets; place the tablet in compartment (1) Multitab function This appliance is equipped with the multitab function, that allows the use of the multitab combi detergent tablets. These products are detergents with a combined cleaning, rinsing and salt functions. They can also contain other different agents depending on which kind of tablets you choose ('3 in 1', '4 in 1', '5 in 1' etc. ). Once this function is selected it will remain active for all following wash programmes. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. When using the multitab function, the cycle duration may change. 14 electrolux Activate/deactivate the multitab function before the start of a washing programme. Once the programme is running, the multitab function can NO longer be changed. If you want to cancel the multitab function you have to cancel the programme setting and then deactivate the multitab function. In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multitab function To activate the Multitab function, press the Multitab button. · The activation/deactivation of the rinse aid is only possible with the Multitab function active. Cancel a delay start or a washing programme in progress · Press and hold the cancel button, until all the programme indicator lights come on. · If you cancel a delay start also the washing programme and options (except Multitab) will be cancelled. · If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. End of the washing programme · The appliance stops automatically. Open the appliance door, leave it ajar and wait a few minutes before removing the dishes. If the save energy function is set, dishes can be wet once the programme has finished. We recommend to leave the appliance door ajar so that dishes can dry naturally. Standby mode If you do not switch off the appliance at the end of the washing programme, the appliance automatically goes into standby mode. Three minutes after the end of the programme, all indicator lights go off and the digital display shows one horizontal bar. Press one of the buttons (not the on/off button), to go back to end-of-programme mode. Unloading the dishwasher · Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. · Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. [. . . ] If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · The electrical cable for the safety valve is in the double-walled water inlet hose. · If water inlet hose or the safety valve is damaged, remove the mains plug immediately. · A water inlet hose with safety valve must only be replaced by the Service Force Centre. [. . . ]